Spectra Precision Survey Pro v4.6 Ranger Reference Manual - Manual (Page 212)

Survey Pro Reference Manual
R-204
interval on the Job | Settings | Post Process screen and then start
the base and rover using the Start GPS Survey wizard.
Static / RTK Rover Receiver Session
Survey Data Collection -or-
Survey Post Processing
Start … > . -or-
Survey Control Points Post Process -or-
Survey Data Collection Post Process .
The Receiver Session screen is used to enter the station information
and antenna height for a post processing data collection session.
Static Session Stop and Go Session
Store point in
: is used to select how to store this session. You will
always get a session recorded in the post processing log file. Select
Receiver and job file
to store a point record in the Survey Pro .JOB file
as well. By default, post processing points will go on the layer
selected on the Job | Settings | Post Process screen.
Note: The location of the file is usually on the receiver’s built in
memory. However, some models support collection of post processing
data to a file on the data collector. For those receivers that support it,
the location of the log file is specified on the Receiver Settings |
General screen.