Spectra Precision Survey Pro v4.6 Ranger Reference Manual - Manual (Page 198)

Survey Pro Reference Manual
R-190
Base Setup Two – SET
This final Base Setup screen is used to SET the receiver as an RTK
base using the job file point as the reference position, and to configure
the base location in Survey Pro. This screen is shown when the base
point has measured or computed geodetic coordinates in the job.
Base Point
: displays the base point name
chosen in the previous screen.
Latitude
: displays the WGS84 latitude of the
job file point.
Longitude
: displays the WGS84 longitude of
the job file point.
Ellipse
Height: displays the WGS84 height of
the job file point.
Post Processing Recording Interval
: is where
you set the period for logging GPS raw data for
post processing. Set it to Off to disable post processing data
collection.
< Back : returns to the previous Base Setup screen.
SET : sets the receiver as an RTK base, and configures the base
reference position in Survey Pro. If a Post Processing Recording
Interval
is selected, a file will be opened and logging of raw GPS
measurements for post processing will start. The base name and
antenna measurement will be recorded in the file for this static
session.
Base Setup Two – GET and SET
This final Base Setup screen is used to GET an autonomous (HERE)
position from the receiver, SET the receiver as an RTK base, and
configure the base reference position in Survey Pro. This screen is
shown when the selected base point does not have geodetic
coordinates.