Spectra Precision Survey Pro v4.6 Ranger Reference Manual - Manual (Page 199)

Survey Menu – GPS Module
R-191
Base Point
: displays the base point name
chosen in the previous screen.
Latitude
: is where you enter the WGS84
latitude for the base point.
Longitude
: is where you enter the WGS84
longitude for the base point.
Ellipse
Height: is where you enter the WGS84
ellipsoid height for the base point.
Note: You can enter latitude in dd.mmsssss
format with north positive, or you can enter dd mm ss.ssssss N/S. You
can enter longitude in ddd.mmsssssss format with east positive or you
can enter ddd mm ss.sssss E/W.
Average position for epochs before GET
: instructs the receiver to
average autonomous positions for this number of epochs before
returning.
Get Position From Receiver (Rx.) : queries the receiver for an
autonomous position and updates the edit boxes.
Post Processing Recording Interval
: is where you set the period for
logging GPS raw data for post processing. Set it to Off to disable post
processing data collection.
GPS Status : opens the GPS Status screen (Page R-176).
Note: It is highly recommended that you do only one autonomous
base setup per job. This will make it much easier to manage the
transformation from geodetic to local plane coordinates in your job. It
is possible, however, to do multiple autonomous setups in a job. If
you do this, each setup is assigned a unique setup group to identify
them. See the user's manual for more information on setup groups.
SET : sets the receiver as an RTK base, and configures the base
reference position in Survey Pro. If a Post Processing Recording
Interval
is selected, a file will be opened and logging of raw GPS
measurements for post processing will start. The base name and