Spectra Precision Survey Pro v4.6 Ranger Reference Manual - Manual (Page 118)

Survey Pro Reference Manual
R-110
Measure Mode Settings
Job Settings Measure Mode .
The Measure Mode card is used to configure the RTK data collection
settings.
Accept Solution Quality
: is where you control
the solution quality acceptable for storing
measurements. You have two options:
• Fixed RTK only: Allows storage of
fixed solution only.
• Code, Float, or Fix: Allows storage of
any differential solution.
Acceptance Criteria
: is where you select to
apply criteria to measurement acceptance.
When checked, only measurements with RMS
and/or PDOP values below the threshold will
be accepted. To use less than all three criteria, check this box but
enter 0.0 for the criteria you do not wish to apply.
• H RMS: is the horizontal RMS threshold for automatic
acceptance or warning on point acceptance.
• V RMS: is the vertical RMS threshold for automatic
acceptance or warning on point acceptance.
• PDOP: is the PDOP threshold for automatic acceptance or
warning on point acceptance.
Automatically accept data collection…:
is where you select to
automatically accept data collection points when the criteria are met.
When checked, both the data and Offset Shots screens will
automatically accept points once the measurement is better than the
specified criteria. Data collection routines will always collect at least
5 seconds worth of data before automatically accepting points based
on criteria.
Epoch Averaging
: is where you set a number of epochs to average in
Survey Pro. If this number is greater than one, Survey Pro will use