Spectra Precision Survey Pro v4.6 Ranger Reference Manual - Manual (Page 246)

Survey Pro Reference Manual
R-238
cleared for the point and the previous screen is open. If No, we leave
the control point source and go back to the selection screen.
Finish : See the section on Finish below.
Multiple Point Results
This screen displays the values to be used to create the new GPS
control points.
New GPS Control Points to be Created
: For
all of the selected points, this list box shows the
new NEE location, the existing LLH location,
and the existing NEE location.
Show Details : Shows the same details for the
selected point as the Single Point Results
screen shows, described above.
Re-Enter : Clears the control point source for
the selected point in the list box and returns to
the previous screen.
< Back : Returns to the selection screen.
Finish : See the section on Finish below.
Finish
The finish behavior will be one of three cases:
1. Create the control points, solve the localization with all job file
control points, launch the projection readjust wizard and apply
the updated localization to the map projection zone.
2. Create the control points and open the solve localization wizard.
3. Create the GPS control points and exit the wizard.