Spectra Precision Survey Pro v4.6 Ranger Reference Manual - Manual (Page 213)

Survey Menu – GPS Module
R-205
Note: If you are using this screen with the RTK rover, you can only
store points in the post processing log file from this screen. Use the
RTK Data Collection screen to store points in Survey Pro
simultaneously with points logged to the post processing file.
Point (or) Site ID
: is where you enter the station name for the static
session or stop and go point.
Note: When the memory on the receiver is less than 25%, a warning
message will be displayed and you will then have the opportunity to
delete selected files using the File Management screen (Page R-247).
Description
: is where you enter the description for the static session
or stop and go point.
Session Duration
: is where you enter the session length for the next
occupation.
Log Until Stop
: is where you select to use a Duration or to record until
Stop is tapped.
Antenna
: displays antenna setup for this receiver. It will be in one of
two states:
• Last
Antenna
: is displayed when you have not yet set this
receiver in Survey Pro. This value is the previous antenna
measurement you used with this receiver.
• Selected
Antenna
: is displayed when you have entered new
antenna measurements using the Receiver Antenna screen
(Page R-188)
Set HR : displays the current antenna measurement and measure to
setting. You can change the antenna measurement by entering a new
value in the edit box. This new antenna height will be sent to the
receiver with your next control or check point collection. You can
change both the antenna measurement and measure to setting by
tapping on Set HR to open the Receiver Antenna screen (Page R-188).