Spectra Precision Survey Pro v4.6 Ranger Reference Manual - Manual (Page 126)

Survey Pro Reference Manual
R-118
information on adding a modem connection, see Using a
Cellular Phone in the Basic GPS Module section of the User’s
manual.
• IP Address of Base: is the IP address of the base, as provided
by the Internet service.
• Port (Socket) of Base: is the socket number of the base, as
provided by the Internet service.
Change Radio Settings Screen
Job Settings Radio Settings Change Radio Settings .
The Change Radio Settings screen is used to
view the current base radio settings and
change the channel/sensitivity.
Channel
: displays the last radio channel when
applicable.
Sensitivity
: displays the last radio sensitivity
when applicable.
Baud
: displays the baud rate the receiver will
use to communicate with the modem.
Parity
: displays the parity the receiver will use
to communicate with the modem.
Configure
: is where you can configure the channel the radio will use
to communicate with the other radio and the sensitivity of the radio.
Set : sends commands to the radio firmware to configure the settings
selected on this screen.
Note: some settings on the radio cannot be modified with Survey Pro.
To fully program the radio modems, you need to PC software that
should be supplied with the radio.