Spectra Precision Survey Pro v4.6 Ranger Reference Manual - Manual (Page 200)

Survey Pro Reference Manual
R-192
antenna measurement will be recorded in the file for this static
session.
Rover Setup
The Rover Setup screen is used to set the RTK rover receiver, and to
configure or check the base reference position in Survey Pro.
Rover Status
: displays the status of the rover
setup in Survey Pro.
Base set at
: displays the current base point.
This will be empty if the base is not set.
Detail : opens a screen that displays the
geodetic position of the base.
Antenna
: displays antenna setup for this
receiver. It will be in one of three states:
• Last Antenna for this receiver: is
displayed when you have not yet set
the rover in Survey Pro. This value is the previous antenna
measurement you used with this receiver.
• Selected
Antenna
: is displayed when you have entered new
antenna measurements using the Receiver Antenna screen
(Page R-188).
• Antenna
Set
: is displayed when you have already set the rover
in Survey Pro, and this receiver was used as the rover.
Measured
: is where you enter the height of the antenna, measured to
the location specified on the Receiver Antenna screen (Page R-188).
Offset
: displays the vertical and/or slant offset values for the selected
antenna. Entering antenna offsets is explained on the Receiver
Antenna screen, (Page R-188).
Setup HR : opens the Receiver Antenna screen (Page R-188).
Post Processing Recording Interval
: is where you set the period for
logging GPS raw data for post processing. Set it to Off to disable post
processing data collection.
Set Rover: sets the receiver as an RTK rover. If there is a Recording
Interval
set on the Job | Settings | Post Process page, a file will be