Yokogawa GD40 Gas Density Detector - Manual (Page 163)

<9. CALORIE / CALIBRATION PROCEDURE>
9-4
IM 11T3E1-01E
[NO]
[ENT]
*RANGE
[NO]
XXX.XXX
*Z_CAL
*ALARM *CAL.DT
X.XXXX
*Z_DNS
X
*C_HLD
XXX.X
*PR.SET
[ENT]
[ENT]
[ENT]
F0903.ai
[YES]
* 2
* 3
*1: See "Figure 6.4 Process at the Setting Level" on page 6-12.
*2: Set a value using the [ ], [ ] and [ENT] keys.
If you enter a value that exceeds the limits, the display shows [*OVER].
Press the [YES] or [NO] key to re-set the value.
*3: This step is skipped if the parameter [*C_HLD] is set to a value other than "2".
* 1
[ENT]
XXX.XXX
*S_CAL
X.XXXX
*S_DNS
[ENT]
* 2
* 2
* 2
* 2
* 2
(Setting of preset value)
(Setting of Zero-point calorific value)
(Setting of Zero-point density)
(Setting of Span-point calorific value)
(Setting of Span-point density)
(Setting of Output hold value during calibration)
Figure 9.2 Calibration Parameter Setting Mode