Yokogawa Integral Oxygen Analyzer ZR202 - Manual (Page 81)

IM 11M12A01-05E 7-8
7.4.5 Changing Set Values
(1) Selecting numeric values from among preset values
Switch operation Display Description
ENT
ENT
ENT
ENT
ENT
T7.4.5.1E.EPS
.
.
.
.
.
.
.
.
.
.
.
.
.
0
1
2
0
The set value is displayed after the parameter code selection. An example of how to
select either 0, 1, or 2 as the set value is given below.
(The currently set value is 0.)
Touch the [ ] key once to change the current value from 0 to 1.
Touch the [ ] key again to change to the numeric value 2.
If you touch the [ ] key again, the numeric value will return to 0.
Continuously touch the key, and the numeric values will change continuously.
Display the desired numeric value and touch the [ENT] key.
The display will then return to the parameter code selection
C 01
(2) Entering numeric values for the humidity and factors
T7.4.5.2E.EPS
The set value is displayed after the parameter code selection.
An example of entering "9.8" is given below. (The currently set value is 0.0)
Touch the [>] key to move the position of the digit that is flashing to the
digit to be changed.
Continuously touch the [>] key, and the position of the digit that is flashing
will move continuously to the right.
Touch the [ ] key to set the numeric value 9.
Continuously touch the [ ] key, and the numeric value will change in sequence
from 0 to 1 to 2 to 3 … to 8 to 9 and back to 0.
Touch the [>] key to move the position of the digit that is flashing to the right.
Touch the [ ] key to set the numeric value 8.
After the numeric value appears, touch the [ENT] key.
If you touch the [ENT] key again, the flashing stops and the current set value
will be in effect.
Touch the [ENT] key once again to return to the parameter code selection display.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
Switch operation Display Description
0 0.0
0 0 .0
0 9 .0
09. 0
09. 8
09.8
09.8
C 11
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
.
.
.