Yokogawa Integral Oxygen Analyzer ZR202 - Manual (Page 80)

IM 11M12A01-05E 7-7
7. Startup
7.4.4 Selecting Parameter Codes
Table Parameter Code Selection
Switch operation Display Description
. ENT
. ENT
. ENT
. ENT
. ENT
. ENT
. ENT
. ENT
T7.4.4EEPS
.
.
.
.
.
.
.
.
The symbol [ ] indicates that the key is being touched. Light characters indicate that the digits are flashing.
A01
A 0 1
A0 1
A 01
b 01
C 01
d 01
Set Value
.
.
Password has been entered and the parameter code selection display has appeared.
Character A is flashing, indicating that character A can be changed.
If you touch the [>] key once, the position of the digit that is flashing will move to the right.
This allows you to change 0.
Touch the [>] key again to move the position of the digit that is flashing to the right one m
ore digit. This enables you to change numeric character 1.
Touch the [>] key again to return the position of the digit that is flashing to A. Continuously
touch the [>] key, and the position of the digit that is flashing will move continuously to the
right.
If you touch the [ ] key once, character A will change to B.
Touch the [ ] key once to change to C.
Continuously touch the [>] key, and the value of the digit that is flashing will increase
continuously, from D to E to F to G to A. Numeric values will change from 0 to 1 to 2 to 3 …
to 8 to 9 and back to 0. However, numbers that are not present in the parameter codes, will be
skipped. Each digit is changed independently. Even though a low-order digit changes from
9 to 0, a high-order digit will not be carried.
After you select the desired character, touch the [ENT] key. The set data will be displayed.