Maple Systems MAPware-7000 - Manual (Page 20)

MAPware-7000 Ladder Logic Guide 12
1010-1041 rev. 00
Instruction Name Symbol Description Execution
Time (μSec)
Upper Limit Compares the current value in a register
A with a set value in B. If the current
value A is less than B, then A is stored in
result C. If A is greater than B, B is stored
into C. 2.3 μsec
Lower Limit Compares the current value in a register
A with a set value in B. If the current
value A is greater than B, then A is stored
in result C. If A is less than B, B is stored
into C. 2.1 μsec
Maximum Value Searches for the maximum value in a
table of registers (of size n), beginning
with register A, then stores the maximum
value into register B. 4.0 to 64.6
μsec
Minimum Value Searches for the minimum value in a
table of registers (of size n), beginning
with register A, then stores the minimum
value into register B. 3.9 to 61.1
μsec
Average Value Computes the mean average value of a
table of registers (of size n), beginning
with register A, then stores the result into
register B. 12.5 to 39.7
μsec
Function Generator Finds f(x) for given x=A, and stores result
in C. The function f(x) is defined by
parameters stored in a table of registers
(of size 2n), beginning with register B. 5.2 to 68.8
μsec
Data Log Upload Uploads data logger from attached USB
Special Instructions
These are instructions which include data processing functions, I/O instructions, and RAS.
Instruction Name Symbol Description Execution
Time (μSec)
Device Set Sets target coil address to ON. 1.1 μsec
Device Reset Clears target coil address to OFF. 1.1 μsec