Maple Systems HMC7000 Series - Manual (Page 58)

HMC7000 Series I/O Module Guide
Phone: 425/745-3229 • Fax: 425/745-3429 • Email: [email protected] • www.maplesystems.com .
1010-1043 Page 57 of 85 Rev. 02, 11/08/2013
Configuration:
Use MAPware-7000 to assign input (X and XW), output (Y and YW), and configuration (M and MW) memory
addresses to the module. These addresses are created according to the slot location of the module, where nn refers
to the slot number
(ex. 01…05):
Function Register Access
X0-X7 Inputs Xnn000-007 (XWnn00) Rd Only
Y0-Y7 Outputs Ynn000-007 (YWnn00) Rd/Write
High Speed Counter
Option HSC Ch. 1 HSC Ch. 2 HSC Ch. 3 HSC Ch. 4
HSC Input
X0 (terminal)
Xnn000 (reg) X5 (terminal)
Xnn005 (reg) X2 (terminal)
Xnn002 (reg) X7 (terminal)
Xnn007 (reg) Rd Only
HSC Reset Input X1 (terminal)
Xnn001 (reg) X6 (terminal)
Xnn006 (reg) X3 (terminal)
Xnn003 (reg) X4 (terminal)
Xnn004 (reg) Rd Only
HSC Output Flag Y1 (terminal)
Ynn001 (reg) Y6 (terminal)
Ynn006 (reg) Y7 (terminal)
Ynn007 (reg) Y0 (terminal)
Ynn000 (reg) Rd/Write
HSC Configuration
Register MWnn00 MWnn06 MWn112 MWn118 Rd/Write
HSC Counter Register
(Current Value) MWnn01
MWnn02 MWnn07
MWnn08 MWnn13
MWnn14 MWnn19
MWnn20 Rd/Write
HSC Preset Register MWnn03
MWnn04 MWnn09
MWnn10 MWnn15
MWnn16 MWnn21
MWnn22 Rd/Write
HSC Enable Bit Mnn080 Mnn176 Mnn272 Mnn368 Rd/Write
HSC Reset Bit Mnn081 Mnn177 Mnn273 Mnn369 Rd/Write
Quadrature Inputs Pair 1 Pair 2
Counter Inputs X0, X5 X2, X7 Rd Only
Counter Reset Input X1 X3 Rd Only
Output Flag Y1 Y7 Rd/Write
PWM Outputs PWM1 PWM2
Output Y2 Y4 Rd Only