Teledyne LeCroy WaveLink Differential Probe Series (13-25 GHz) - Manual (Page 61)

Operator's Manual
WL-HBW-A-OM-E Rev B 55
Vertical dialog with labeled tab corresponding with your attached probe.
3. Turn on the channel corresponding to the connected probe.
4. Touch the probe-connected channel's trace label. The Cx Vertical Adjust dialog is shown.
Verify the probe model. The D1605 , is shown (previous).
5. Touch the D1605 indicator tab to show the D1605-A probe dialog as follows:
Channel trace descriptor label and Probe dialog contains data corresponding with
your attached probe.
6. Touch the Power On checkbox to verify the AutoColor ID LEDs on the probe is OFF (and
probe power is OFF). Turn the power back ON by clicking the checkbox again.
7. Touch the Led On checkbox to verify the probe's AutoColor ID LEDs turn off (probe power is
still ON). Turn LEDs back ON.