Teledyne LeCroy WaveLink Differential Probe Series (13-25 GHz) - Manual (Page 41)

Operator's Manual
WL-HBW-A-OM-E Rev B 35
R
EMOVING THE
T
IP
R
ETAINING
C
LIP
Remove the retaining clip from the board by pulling on the tab of the adhesive pad. The clip can now
be removed easily without leaving any adhesive residue and can be used in another application
using a new adhesive pad.
Removing the retaining clip
Platform/Cable Assembly Mounting Kit
Platform/Cable Assembly Mounting Kit (PK600ST-4) can be used to support to the platform/cable
assembly and relieve stress on interconnect leads when the test points are located close to the edge
of the board under test.
The PK600ST-4 includes one board edge clip and four adhesive backed platform/cable assembly
clamps.