Teledyne LeCroy WaveLink Differential Probe Series (13-25 GHz) - Manual (Page 15)

Operator's Manual
WL-HBW-A-OM-E Rev B 9
Amplifier Modules (includes solder-in interconnect leads)
Product
Code
13 GHz WaveLink
13GHz, 2.0Vp-p, ±2.5V Offset Range, and ±4V Common Mode Range Amplifier Module with
Dxx05-SI Solder-in Lead (Qty. 2). Also Includes: Replacement Resistors (Qty. 10), Tip Retaining
Clips (Qty. 2), and Protective Storage Case.
Must be ordered with a WL-PLINK-A-CASE Platform/Cable Assembly to achieve warranted
calibration. If desired, this Amplifier Module may also be used with a WL-2.92MM-
CASE Platform/Cable Assembly with a 13 GHz bandwidth limitation. All amplifier modules and
platform/cable assemblies must be calibrated as a system at time of shipment.
D1305-A
16 GHz WaveLink
16 GHz, 2.0Vp-p, ±2.5V Offset Range, and ±4V Common Mode Range Amplifier Module with
Dxx05-SI Solder-in Lead (Qty. 2). Also Includes: Replacement Resistors (Qty. 10), Tip Retaining
Clips (Qty. 2), and Protective Storage Case.
Must be ordered with a WL-PLINK-A-CASE Platform/Cable Assembly to achieve warranted
calibration. If desired, this Amplifier Module may also be ordered with a WL-2.92MM-
CASE Platform/Cable Assembly with a 16 GHz bandwidth limitation. All amplifier modules and
platform/cable assemblies must be calibrated as a system at time of shipment.
D1605-A
20 GHz WaveLink
20GHz, 2.0 Vp-p, ±2.5V Offset Range, and ±4V Common Mode Range Amplifier Module with
Dxx05-SI Solder-in Lead (Qty. 2). Also Includes: Replacement Resistors (Qty. 10), Tip Retaining
Clips (Qty. 2), and Protective Storage Case.
Must be ordered with a WL-PLINK-A-CASE Platform/Cable Assembly to achieve warranted
calibration. If desired, this Amplifier Module may also be ordered with a WL-2.92MM-CASE
Platform/Cable Assembly with a 20 GHz bandwidth limitation. All amplifier modules and
platform/cable assemblies must be calibrated as a system at time of shipment.
D2005-A
25 GHz WaveLink
25GHz, 2.0Vp-p, ±2.5V Offset Range, and ±4V Common Mode Range Amplifier Module with
Dxx05-SI Solder-in Lead (Qty. 2). Also Includes: Replacement Resistors (Qty. 10), Tip Retaining
Clips (Qty. 2), and Protective Storage Case.
Must be ordered with a WL-2.92MM-CASE 25 GHz Platform/Cable Assembly to achieve warranted
calibration.
May also be used with a WL-PLINK-A-CASE Platform/Cable Assembly but will achieve lesser
bandwidth. All amplifier modules and platform/cable assemblies must be calibrated as a system at
time of shipment.
D2505-A