IAI America PCON-CFA - Manual (Page 55)

3. SCON-CA/CF
A
49
(1) PLC address configuration (* n indicates the initial input/output address for each axis.)
Parameter
No. 84
ACON/PCON DI and
input register
PLC output address
ACON/PCON DO and
output register
PLC input address
Port number 0 to 15 n+0 Port number 0 to 15 n+0
n+1 Occupied area n+1
n+2 n+2
n+3
Current position
n+3
n+4 n+4
4
Occupied area
n+5
Command current
n+5
(Note) The [occupied area] cannot be used for any other purpose.
Also pay attention to use of duplicate addresses.
(2) I/O signal assignments for each axis
An I/O signal of each axis consists of 6 words (12 bytes) of I/O addresses.
z Addresses controlled by port numbers are controlled by bit ON/OFF signals.
z The current position is a 2-word (32-bit) binary data (unit: 0.01 mm).
z The command current is a 2-word (32-bit) binary data (unit: 1 mA).
PLC output
address (* n indicates the initial output address for each axis.)
1 word = 2 bytes = 16 bits
Controller
input port
number