IAI America RCS2-SD5N User Manual
Page 67
10. Maintenance and Inspection
-61-
10.6.2 Greasing Method
[1] Turn off the power and check the surface of the spiral cover for shavings, powder dust, etc. Use a rag, etc.,
to wipe off shavings, powder dust, if any.
[2] Extend the rod and pull the narrower end of the spiral cover toward the wider end (in the direction of the
arrow) to expose the screw shaft. If the lead is too small and the rod does not move, insert a slotted
screwdriver, etc., into the cutout groove provided in the shaft on the rear side and turn. [Refer to 8.2, “How
to Move the Rod by Hand.”]
[3] Wipe off grease attached to the lead screw or ball screw and then apply the specified grease.
[4] Install the spiral cover in the original condition and move the rod to spread the grease evenly.
Spiral cover