IAI America RCS2-SD5N User Manual
Page 34
6. Installation
-28-
[6] While keeping this positioning relationship (the cutout groove provided in the shaft on the rear side is
aligned with the marking sticker), turn the shaft counterclockwise to adjust L to the specified dimension.
[7] Use a spanner wrench to hold the width across flats of the end clasp in place and affix it with the guide-side
bracket. (When affixing with the bracket, turn the nut while locking the spanner wrench applied to the end
clasp. If the end clasp turns, the home position becomes offset.)
Tightening torque for end clasp
Type
Tightening torque
RN5N
7 Nxm