IAI America RCS2-SD5N User Manual
Page 43
6. Installation
-37-
[Installation Procedure]
[1] Check the preciseness of brackets on the actuator side and load side.
Adjust the bracket positions so that the preciseness will fall within the following ranges over the entire
moving range of the load:
[2] Install the actuator.
[3] Move the bracket on the load side and confirm once again that its position preciseness with respect to the
bracket at the end of the rod presents no problem. Confirm that the end bracket smoothly enters straight into
the pilot hole in the bracket.
Caution: The position preciseness between the actuator and load must be within the specified ranges.
If not, abnormal noise or vibration may occur or malfunction or premature damage may result.
Bracket on the load side
Bracket on the actuator side
The end bracket must smoothly enter straight
into the hole without making contact.