Notes on operation, 1 placing a load on the actuator, 2 how to move the rod by hand – IAI America RCS2-SD5N User Manual
Page 60
8. Notes on Operation
-54-
8. Notes on Operation
8.1 Placing a Load on the Actuator
x
Make sure the maximum payload capacity specified in 2, “Specifications” will not be exceeded.
x
Align the shaft center of the rod with the moving direction of the load.
8.2 How to Move the Rod by Hand
With the low-lead types whose lead is 2, 5, etc., the rod is too difficult to be moved by hand. To move the rod on
these models, insert a turning jig (optional), etc., into the cutout groove provided in the shaft on the rear side and
turn the groove.
(Note) The slide unit types have no cutout groove in the shaft. On these models, connect a controller to move
the rod.
Cutout groove in shaft
Marking (orange)