Installation, 1 short types (nut affixing types) – IAI America RCS2-SD5N User Manual
Page 29
6. Installation
-23-
6. Installation
6.1 Short Types (Nut Affixing Types)
RN5N
6.1.1 Installation of Actuator
Install the actuator by guiding it through a hole of approx. 5 to 10 mm provided in a smooth plate.
x
Use the nut on the actuator rod to install the actuator onto the actuator mounting plate.
x
The base of the male thread on the actuator side has a tolerance of h8. Use this part as a pilot section.
Type
M
Width across flats
Maximum tightening torque
RN5N
M35 x 1.5
46
50 Nxm
Caution: Do not tighten excessively beyond the maximum tightening torque.
The actuator may be damaged.
Actuator mounting plate
Actuator
Nut