beautypg.com

3 cleaning, 4 inspection of the interior – IAI America RCS2-SD5N User Manual

Page 65

background image

10. Maintenance and Inspection

-59-

10.3 Cleaning

x

Clean exterior surfaces as necessary.

x

Use a soft cloth to wipe away dirt and buildup.

x

To clean the spiral cover, use a soft cloth, etc., to wipe off soiling by working from the large diameter side

toward the small diameter side.

x

Do not blow too hard with compressed air as it may cause dust to get in through the gaps.

x

Do not use oil-based solvents as they can harm lacquered and painted surfaces.

x

To remove severe buildup, wipe gently with a soft cloth soaked in a neutral detergent or alcohol.

10.4 Inspection of the Interior

When inspecting the interior, check the items specified below.

Main unit

Loose actuator mounting bolts, other loose items

Lead screw or ball screw

Lubrication, buildup

To check the lead screw or ball screw, turn off the power, extend the rod, and pull the narrower end of the spiral

cover toward the wider end (in the direction of the arrow) to expose the screw shaft and inspect the shaft visually.

If the lead is too small and the rod does not move, insert a slotted screwdriver, etc., into the cutout groove

provided in the shaft on the rear side and turn. [Refer to 8.2, “How to Move the Rod by Hand.”]

Visually check the lubrication condition of the lead screw or ball screw.

Even when the grease is brown, the screw is lubricated property as long as the traveling surface looks wet and

shiny. If the grease is mixed with dust and dirty or has no shiny appearance, or if the grease has lost its efficacy

due to prolonged use, clean the applicable area and then replenish grease.

Spiral cover

This manual is related to the following products: