IAI America RCS2-SD5N - Manual (Page 45)

6. Installation
-39-
[6] While keeping this positioning relationship (the cutout groove provided in the shaft on the rear side is
aligned with the marking sticker), turn the shaft counterclockwise to adjust L to the specified dimension.
[7] Use a spanner wrench, etc., to hold the width across flats of the end clasp in place and affix it with the
guide-side bracket. (When affixing with the bracket, turn the nut while locking the spanner wrench applied to
the end clasp. If the end clasp turns, the home position becomes offset.)
Tightening torque for end clasp
Type Tightening torque
RP5N 7 Nxm
End bracket