beautypg.com

Handling precautions – IAI America RCS2-SD5N User Manual

Page 13

background image

-7-

Handling Precautions

1. Do not set a speed or acceleration/deceleration exceeding the applicable rating.

Do not set a speed or acceleration/deceleration exceeding the applicable rating. Doing so may result in vibration,

failure or shorter life. If an acceleration/deceleration exceeding the rating is set, creep may occur or the coupling

may slip.

2. Oil film of grease may run out if short-distance reciprocating operation is

performed.

When performing continuous reciprocating operation of a distance of 20 mm or shorter, oil film of grease may

run out. To recover oil film, perform approximately five cycles of a distance of 50 mm or longer, every 5,000 to

10,000 cycles, as a guideline

3. Do not hit the spiral cover with tools or similar or squeeze with fingers.

The spiral cover is a thin panel rolled in spirals. Exercise caution because it is deformed if you hit the spiral cover

with tools or squeeze with fingers.

4. Do not apply external force on the rod from directions other than the rod traveling

direction.

Do not apply external force (radial load) on the rod from directions other than the rod traveling direction. If force

in the perpendicular or rotating direction is applied on the rod, the actuator may be damaged or malfunction.

If external force from directions other than the traveling direction is applied, mount an actuator with guide or

external guide.

5. Do not leave the product for a long time with the work piece attached on.

6. The slider for the actuator of Lead 10 may move when the servo is OFF even if

there is no load applied on it.

7. The operation noise may get loud in some conditions of use.

Spiral cover

This manual is related to the following products: