IAI America RCS2-SD5N User Manual
Page 46
6. Installation
-40-
[8] Confirm smooth movement over the entire stroke range of the load. If the resistance increases or actuator
gets caught in the middle, check the position preciseness again. (In the case of a small-lead actuator
(having a lead of 2 or 5), use a turning jig (optional) to turn the rotary shaft from the rear to move the load.)
Caution: With small-lead actuators (having a lead of 2 or 5), do not directly move the load (rod) back
and forth.
If the rod is forcibly moved, the feed screw will receive an undue load and may cause
malfunction or damage.
Turning jig
(optional)