Ronan X11CA Software Manual - Manual (Page 60)

Rev 1.3 Series X11CA Computer Annunciators: X11CA Configuration Software User’s Manual
4. X11CA Software Operation
Hardware Control-© 2003 Ronan Engineering 56
4.12 Changing Password
1) To change the password, click on the Setup menu and then Password.
2) Enter the old password in the Old Password box.
3) Enter the new password in both the New Password box and the Verify box.
Each letter of the password will appear as an asterisk (*) character for the
security reason.
4) Click on the OK button.
Figure 4-40. Set Password
Window
NOTE:
If you prefer not entering a password when you are programming, leave the New
Password area and the Verify area blank and then click on the OK button.
4.13 Disconnecting from Physical Modules
1) If modules are in Run mode, stop the physical modules from running by
clicking the Stop icon.
2) Disconnect from the module in one of the following two ways.
1. Click on the Disconnect icon ( ).
2. Or click on the System menu and then Disconnect option. (Or
and then key.)
4.14 Exiting from the Configuration Software
Click on the File menu and then the Exit submenu.