Model 9060z manual – Teledyne 9060Z - Zirconium oxide flue gas oxygen analyzer User Manual

Page 5

Model 9060Z Manual

This manual describes the transmitter firmware version 1.24, September 2012

Neither the whole nor any part of the information contained in, or the product described in, this
manual may be adapted or reproduced in any material form except with the prior written approval of
Teledyne Analytical Instruments.

The product described in this manual and products for use with it are subject to continuous
developments and improvement. All information of a technical nature and particulars of the product
and its use (including the information in this manual) are given by Teledyne Analytical Instruments in
good faith. However, it is acknowledged that there may be errors or omissions in this manual. A list of
details of any amendments or revisions to this manual can be obtained upon request from Teledyne
Analytical Instruments. Teledyne Analytical Instruments welcome comments and suggestions relating
to the product and this manual.

All correspondence should be addressed to: ‐

Teledyne Analytical Instruments

16830 Chestnut Street

City of Industry, CA 91748

Phone (626) 934‐1500 or (888) 789‐8168

Fax (626) 934‐1651

Email:

[email protected]

www.teledyne‐ai.com

Teledyne Analytical Instruments or their authorised dealers should carry out all maintenance and
service on the product. Teledyne Analytical Instruments can accept no liability whatsoever for any loss
or damage caused by service or maintenance by unauthorised personnel. This manual is intended only
to assist the reader in the use of the product, and therefore Teledyne Analytical Instruments shall not
be liable for any loss or damage whatsoever arising from the use of any information or particulars in,
or any error or omission in, this manual, or any incorrect use of the product.