Micromod MOD: 30MLTraining Manual - Manual (Page 32)

Training Manual
Single Loop Template Lab
4 Press ENT again to enter
Configuration mode. You will be in
DEV STAT menu mow. See the
sequence of figures below: Lines 1 and 2 will display DEV STATE and
INSTATE (Instrument state). Line 6 will display
RUN indicating that the controller is running a
valid database.
5 Press the NXT key until COMMANDS is
displayed on line 2. You can issue commands to the controller from
this menu.
Figure 3 .6.
6 Press the DOWN key once.
7 Press NXT key until ACK ALL is
displayed on line 2. Used for sending global acknowledge command
causing all diagnostics, alarms and notification
/request messages to be acknowledged.
8 Clear ACK ALL by pressing the DOWN
key.
YES will be displayed on line 6.
9 Press the ENT key. Press NXT key RESET is used to complete tasks and then
perform a power-up
10 Press NXT key KILL is used to perform an immediate power-up
11 Press NXT key DEL MAIN will be displayed on Line 2.
12 Delete Main database by pressing the
DOWN key, then press the ENT key DEL MAIN is used to mark the main database as
bad and set the instrument state to DEFAULT.
The controller ALARM light will be flashing at
this time.
3 - 6