Micromod MOD: 30MLTraining Manual - Manual (Page 207)

Training Manual
Supervisory Message Lab
20. Using the same method, make the following connections:
From: BATCH.StepMgr.SetMode
To: TEMP CONTROL. A/M.SENDINP This triggers the Supervisory Message
block to send the data. It is triggered on a
rising edge. This is why the output from
the Sequence Block is only true for the
HEAT and DRAIN steps, and false in all
other steps.
From: BATCH.StepMgr.Setpoint
To: TEMP CONTROL.PID.RSPI This sends the new setpoint value to the
PID controller.
21. Your blocks should now look like this:
C – ADD THE TEMPERATURE DISPLAY TO THE DIF BLOCK
In order to see the effect of the supervisory message on the temperature controller, we will need a display on the MOD
30ML.
1. Double-click on the DIF block
2. Add the display name PID-100 to the Display Tag List
3. Select User display under ‘Display to use at power-up’ and type
PID-100
4. Close the block.
13 - 9