Micromod MOD: 30MLTraining Manual - Manual (Page 193)

Training Manual
Sequence Lab
• Click on OK to close the dialog box. The Steps tab of the SEQ Properties dialog shows
the step you added.
Figure 12 .21.
SEQ Properties -
Steps Tab
)
Notice that there are columns for the step number, step name, and expression, and
for each output you added in the Outputs tab. Up to 64 outputs can be configured in
one Sequence block, and each output can assume a different state or value for each
step.
• Add more steps as per the following table:
Step # Step Name ChargeV DrainV Setpoint CtrlMode SetMode
2 Charge True False 0 0 False
3 Heat False False 90 1 True
4 Cook False False 90 1 False
5 Cool False False 20 1 False
6 Drain False True 0 0 True
The outputs “CtrlMode” and “SetMode” will be used to change the temperature
controller from Manual to Automatic in the Supervisory Message lab.
12 - 15