Micromod MOD: 30MLTraining Manual - Manual (Page 112)

Training Manual
PID Loop Lab
Figure 6 .47.
Closing Compound
23. Add a Configured list block and add signals to it: Next we will need to add parameters to
pass on the Extended Modbus that can be served by the XModbus OPC Server or a
XModbus Device Driver to Client Software packages like HMI/HSI clients. This is
needed only if you connect your controller to a host computer. If your controller will be
stand-alone, you do not need to send parameters over Modbus/ XModbus. In this course,
we will be using XModbus to pass parameters such as PV, SP, OP etc.
• Pick a CL block from the Algorithms window and add it to the document
(strategy) workspace.
• Double-click on it to configure: The CL block Properties will open as shown
below.
• Click on the Inputs tab to add inputs
6 - 32