Micromod MOD: 30MLTraining Manual - Manual (Page 229)

Training Manual
Sequence Display Lab
17.3 Instructions
Make sure the database you constructed in the Sequence Lab and modified in the Supervisory
Message lab is loaded in ViZapp. You should be at the top level with the DIF, IF, ST, and SE
blocks visible along with the BATCH and TEMP CONTROL compounds.
A – DESIGN THE DISPLAY
The first step to creating a custom display is to plan what will appear on each line, and whether the
keys will perform different functions than the standard configuration (PID loop). In this particular
display some of the keys are not used at all.
For the purposes of this lab the display design has already been done. Study the Planning
Worksheet below to make sure you understand what the display will do.
MOD 30ML CUSTOM DISPLAY PLANNING WORKSHEET
DISPLAYS:
STATE
TABLE? SCRIPT?
LINE 1 Current Step from Sequence Block Yes No
LINE 2 Time in step from Sequence Block No No
LINE 3 Blank No No
LINE 4 Blank No No
LINE 5 RUN or ENT when in Idle step, blank in all other sNo No
LINE 6 YES/NO in Idle step, for operator start Yes Yes
Temperature in Heat, Cook and Cool steps
Blank in all other steps
FUNCTION
Bar 1 Not used TAG Change displays (standard) No No
Bar 2 Not used MANUAL Not used No No
Bar 3 Not used AUTO Not used No No
R/L Not used No No
SCROLL ENT (enter) to start batch No No
UP/DN Changes between YES and NO on line 6 Yes No
17 - 3