Micromod MOD: 30MLTraining Manual - Manual (Page 162)

Training Manual
Peer-to-Peer Communications
Figure 10 .8.
PID Block
Connection Menu
• The connection will now be complete. The connection line will have the source name and
destination name displayed right on it as shown in the figure below. The signal from the other
instrument on the ICN will now be the Output Track signal for this PID block.
Figure 10 .9.
PID Block
Connection Menu
4. Configure another Input Communication Block:
• Place another IC block and configure it from instrument 2’s OC2 to the PID block’s TCI (Track
Command Input). Note that this will be a Discrete signal.
5. Configure the Output Communication Block:
• Select the OC (Output Communications) block from the Algorithms window and add it to the
document near to the PID block. Note: The OC blocks can only be added from within a Loop
Compound.
10 - 6