Micromod MOD: 30MLTraining Manual - Manual (Page 101)

Training Manual
PID Loop Lab
Figure 6 .30.
Right Angle
connection
• Click on the output point of the FY-100 block. This point is the result of the FY-
100 input function block. The fly-by box will say R when you click on the output.
Drag the line to the input point of the PID block and clock on it (PVI) to complete
the connection.
17. Connect the output of the PID (FIC-100) to the INPUT of the AOUT (analog output)
block with the right angle connector as shown below.
Figure 6 .31.
Right Angle
connection
If you made a mistake while connecting, or if you do not know where to connect, you
can always cancel it or get out of the connection mode by clicking on the right mouse
button to show a menu as shown below:
• Select Cancel from this menu to cancel the connection.
6 - 21