ALLIED Vision Technologies Marlin F-201 - Manual (Page 135)

Controlling image capture
MARLIN Technical Manual V2.4.0
135
Changing the parameters within a sequence
To change the parameter set for one image, it is not necessary to modify the
settings for the entire sequence. The image can simply be selected via the
ImageNo field and it is then possible to change the corresponding IIDC V1.3
registers.
Points to pay attention to when changing the
parameters
Note
L
• If the ApplyParameters flag is used when setting the
parameters, all not-configured values are set to default
values. As changing a sequence normally affects only
the value of a specific register, and all other registers
should not be changed, the ApplyParameters flag may
not be used here.
• The values stored for individual images can no longer
be read.
• If the camera is switched into sequence mode, the
changes to the IIDC V1.3 registers for the image speci-
fied in ImageNo take immediate effect.
• Sequence mode requires firmware 3.03 and special care
if changing image size and frame rate related parame-
ters. This is because these changes not only affect
settings in the camera but also require corresponding
settings in the receiving software in the PC (e.g.
FirePackage).
Caution
a
• Incorrect handling may lead to image corruption or
loss of subsequent images.
• Please ask for detailed support if you want to use
this feature.