B&K Precision 2542B-GEN - Manual - Manual (Page 86)

Menu Operation
86
Follow the following steps to manually configure the LAN
interface:
 Set the IP Address. Contact your network administrator
for the IP address to use. All IP addresses take the
dot-notation form “nnn.nnn.nnn.nnn” where “nnn” in each
case is a byte value in the range 0 through 255. Move the
cursor to the IP address position and change the IP
address using the entry knob.
 Set the Subnet Mask. The subnet mask is required if
your network has been divided into subnets. Move the
cursor to the subnet mask position and enter the subnet
mask in the IP address format using the entry knob.
 Set the Gateway IP. The gateway address is the
address of a gateway which is a device that connects two