1 system message, System message, Troubleshooting guide – B&K Precision 2542B-GEN - Manual User Manual
Page 216

Troubleshooting Guide
216
8.1 System Message
Function is not available: The control knob, key, or softkey
is not available under a specific operating condition. This
message will be displayed when you try to operate these
knob, key , or softkey.
The control is at its limit: This message will be displayed
when the maximum or minimum value has reached from
turning the Entry knob, Vertical Control knobs, Horizontal
Control knobs, or Trigger Level knob.
Total is at its maximum: This message will be displayed
when the maximum value of Total count for PASS/FAIL has
reached.
Record is completed: This message will be displayed when
the number of waveforms (set in the End Frame softkey)
have been recorded or when you press the Operate softkey
to stop the record process manually.
No external memory: This message will be displayd when
you try to save a file to an external mass storage device
which has not been installed.
Save error: This message will be displayed when you fail to
save a file to the internal or external memory.