B&K Precision 2542B-GEN - Manual - Manual (Page 34)

Basic Operation
34
various parameters. If signal is found, it will beep once and
open the AUTO menu before displaying the signal. If there
are no signals, no beep will occur and a display message will
read “No signal is found”.
To configure the oscilloscope to display multiple cycles, press
Multi-Cycle softkey in the AUTO menu.
To configure the oscilloscope to display a single cycle, press
Single Cycle softkey in the AUTO menu.
To undo the effects of Autoset, press the Undo Autoset
softkey in the AUTO menu before pressing any other key.
This is useful when you have unintentionally pressed the
AUTO key or do not like the settings Autoset has selected
and want to return to your previous settings.