Franklin Fueling Systems TS-DTU Data Transfer Unit Dispenser Retrofit Manual - Manual (Page 4)

4 General Information
Purpose:
This procedure describes the tools, methods and skill levels required to install an INCON/Franklin Fueling Systems model
TS-DTU, Data Transfer Unit in UL Approved Dispensers. Each installation of a TS-DTU in a dispenser requires that a TS-
DRK, dispenser installation kit, be used. The TS-DRK is ordered by specifi c dispenser types. Please refer to the Table
1 for the correct TS-DRK model. Only INCON/Franklin Fueling Systems trained and certifi ed contractors will be able to
perform these retrofi ts or warranty will be void. The installer shall be a skilled petroleum technician and thoroughly familiar
with the requirements of State, Federal and local codes for installation and repair of gasoline dispensing equipment. Also,
they shall be aware of all the necessary safety precautions and site safety requirements to assure a safe and trouble free
installation. NOTE: All electrical fi ttings referred to in these instructions must be UL “listed” or “recognized” for the purpose.
Important Safety Messages
Before installing the equipment, read, understand and follow:
- The National Electrical Code (NFPA 70)
- The Automotive and Marine Service Code (NFPA 30A)
- Any national, state and local codes that may apply.
The failure to install the equipment in accordance with NFPA 30A and 70 may adversely affect the safe use and operation
of the system. Accurate, sound installations reduce service calls: Use experienced, licensed contractors that practice
accurate, safe installation techniques. Careful installation provides a sound troubleshooting framework for fi eld repairs and
can eliminate potential problems.
1. Read all instructions before beginning.
2. Follow all safety precautions:
• Barricade the area.
• Do not allow vehicles or unauthorized people in the area.
• Do not smoke or allow open fl ames in the area.
• Do not use power tools in the work area.
• Wear eye protection during installation.
3. Use circuit breaker for multiple disconnects to turn off power and prevent feedback from other dispensers.