Franklin Fueling Systems TS-DTU Data Transfer Unit Dispenser Retrofit Manual - Manual (Page 23)

23
Tokheim Premier C DTU Installation
Figure 16: Power Cable Installation
36. Attach connector from the Tokheim power harness
into available connector on AC power distribution
board.
Figure 17: Attach White Connector
37. Attach ring terminal of ground wire to dispenser
bracket using screw and nut as shown. Coil excess
wiring with tie wraps to ensure that it does not
interfere with door closing
Figure 18: Ground Wire Attached
38. Find cable assembly extending from TS-VFM vapor
meter in dispenser hydraulics enclosure.
39. Find wiring from previously installed potted nipple
assembly inside hydraulics enclosure.
40. Find two wire splice connector kits. Inside
hydraulics enclosure connect black wire from potted
nipple assembly to black wire from TS-VFM fl ow
meter by placing each lead into an opening in the
wire splice connector and push fi tting closed to lock.
41. Find the cable extending from TS-VPS inside
hydraulics enclosure. Cut yellow and blue leads
from end of cable.
42. Find purple and white wires from potted nipple
assembly in hydraulics enclosure. Strip wiring
insulation
3 /
8
” from end of wire.
43. Using wire nuts provided with kit, attach purple wire
from potted nipple assembly to black wire of TS-
VPS and white wire from potted nipple assembly to
white wire of the TS-VPS.
44. Close right door assembly and tighten latch. Refer
to Figure 3.
45. Close center door assembly and tighten latch.
Refer to Figure 2.
46. Close and lock left options door.
47. Repeat steps 45 through 47 for opposite side of
dispenser.