Extron Electronics MKP 3000 Series - Manual (Page 54)

MKP 3000 Series • Reference Information MKP 3000 Series • Reference Information
Reference Information, cont’d
A-8
TEXT
Separate two
piece button here.
Use notch to
remove button.
Figure A-3 shows the dimensions for cutting a hole to mount an
MKP 3000 L on a lectern or other flat surface.
Cut-Out Template
For MKP 3000 L
TEMPLATE IS NOT FULL SIZE.
Recommended
cut-out area
for the installation
surface.
Top Panel
6.15"
(15.6 cm)
3.15" (8.0 cm)
SURFACE
CUT-OUT AREA
FOR MOUNTING
2.75" (7.0 cm)
5.50"
(14.0 cm)
Position of Controller
Figure A-3 — MKP 3000 L panel mount cutout
template
Extron Comm-Link Control System cable
Wire specifications for Extron Comm-Link cable (figure A-4) are
as follows:
A (red) = 18 American Wire Gauge (AWG)
B (violet or blue) = 22 AWG (grouped and shielded)
C (white) = 22 AWG
D (drain) = 24 AWG
E (black) = 18 AWG
Comm-Link cable was designed for use with MKP
control panels.
SuperFlex Plenum
Jacket
Fiber Wrap
Two 22 AWG
(White and Violet or Blue)
One 24 AWG
Tinned Copper Drain Wire
(foil-shielded group) B, C
D
Two 18 AWG
(Red and Black) A, E
Figure A-4 — Extron Comm-Link cable
Changing Button Labels
The MKP ships with default labels installed in the front panel
buttons (see figure 3-2, “Input/output selection mode labels”).
It also includes a strip of alternate labels that you can insert in
one or more of the mode selection buttons to make using the
other modes clearer.
To change the labels in the MKP’s buttons,
1 . Remove the button from the MKP
by grasping the button firmly and
pulling it away from the panel.
Various button models are
available. Your buttons may
appear different.
2 . Use a small screwdriver or Extron
Tweeker to gently lever the button
cap off of the white backing plate.
3 . Insert a button label into the cap
and gently but firmly press the
cap onto the white backing plate.
4 . Press the button into place in the MKP.
A-9