Extron Electronics MKP 3000 Series - Manual (Page 5)

MKP 3000 Series • Quick Start Guide
Quick Start Guide — MKP 3000, cont’d
i MKP 3000 Series • Table of Contents
Chapter 1 • Introduction .......................................................... 1-1
About this Manual ................................................................ 1-2
About the MKP 3000 Series Remote Control
Panels
........................................................................................... 1-2
Setup examples ...................................................................... 1-3
RS-232 connection to the switcher ....................................... 1-4
Ethernet connection to the switcher ................................... 1-4
Application diagram .............................................................. 1-4
Chapter 2 • Installation ............................................................. 2-1
MKP Installation Overview ............................................... 2-2
Installation Procedures ....................................................... 2-3
Preparing the site .................................................................. 2-3
UL requirements for wall box installation ........................... 2-4
Installing a mounting bracket (mud ring) or wall box ........ 2-4
Mounting the MKP to a mud ring or wall box .................... 2-7
Mounting the MKP 3000 L .................................................... 2-8
Mounting the MKP 3000 L in a lectern .......................... 2-8
Mounting the MKP 3000 L in a rack ............................... 2-8
UL requirements for rack mounting ............................... 2-9
Rear Panel and Side Panel Connections .................. 2-10
Control connections ............................................................ 2-13
RS-232 connection ......................................................... 2-13
RS-232 cable termination .............................................. 2-14
Ethernet connection ...................................................... 2-15
Ethernet (TP) cable termination ................................... 2-16
Power supply wiring ............................................................ 2-18
Mounting the MKP 10 MAAP ......................................... 2-19
Chapter 3 • Local Operation .................................................. 3-1
Front Panel Controls and Indications ......................... 3-2
Front Panel Operations ....................................................... 3-4
Changing the tie mode ......................................................... 3-4
Creating ties ........................................................................... 3-5
Creating a tie in matrix mode (default) ......................... 3-5
Creating a tie in input-only mode .................................. 3-7
Deselecting a tie .............................................................. 3-8
Viewing ties ........................................................................... 3-9
Selecting a preset ................................................................ 3-10
Adjusting the audio output ................................................ 3-10
Table of Contents
QS-2
Step 10
Program the control panel with the size of the connected switcher .
See “System Settings page” in chapter 5, “HTML Operation.”
Step 11
Use the control panel to select inputs and outputs . See “Front Panel
Operations” in chapter 3, “Local Operation.”