Extron Electronics MKP 3000 Series - Manual (Page 25)

MKP 3000 Series • Local Operation MKP 3000 Series • Local Operation
Local Operation, cont’d
1 . Press and hold the I/O button until it lights red to indicate
audio volume mode (approximately 2 seconds), then
release the button.
• The output button lights.
• The LCD display shows the selected ( > ) output and
a slide bar that shows the audio output level of the
selected output.
2 . Press and release the Output button to toggle between
selection ( > ) of the output and the audio level slide bar.
3 . Use the Select knob to select an output, or to increase or
decrease the audio level.
• If Output is selected ( > ), the Select knob scrolls
through the outputs.
If an optional MKP 10 MAAP keypad is connected or
you are using an MKP 3000 L, you can use the keypad
in place of the Select knob. See “MKP 10 MAAP and
MKP 3000 L Keypad Operation,” later in this chapter.
• If the audio level slide bar is selected, the Select knob
changes the audio level.
4 . To exit audio volume mode, press and hold the I/O button
for approximately 2 seconds until the button lights amber
to indicate I/O selection mode.
Viewing and configuring the IP and MKP setup
parameters
To configure the MKP to operate in your LAN, you may need to
change one or more IP addresses and the host control port
setting. The duration of the LCD display’s back light is also
adjustable. Figure 3-7, “Selecting setup parameters,” later in
this chapter, provides a diagram of the procedures for setting up
the IP connection, backlight duration, and tie mode parameters
using the front panel controls.
The following MKP parameters can be set from the front panel
in setup mode:
• IP address (default = 192.168.254.253)
• Subnet address (default = 255.255.0.0)
• Gateway address (default = 0.0.0.0)
• The host matrix switcher’s IP address (default = 0.0.0.0)
• Host control port setting (pass-through or no pass-
through) (default = no pass-through)
3-11 3-10
Selecting a preset
SELECT
TAKE OUTPUT
INPUT
HOLD
PRESET
VIDEO
GREEN
AUDIO
RED
Figure 3-5 — Suggested button labels for preset
mode
• Presets must have been created in the matrix switcher
to be valid. Refer to the user’s manual for the
connected matrix switcher to create presets.
• Presets must be named in the MKP 3000 to be
recallable. See chapter 4, “SIS ™ Operation,” and
chapter 5, “HTML Operation,” to name presets.
To select (recall) a preset on the MKP 3000,
1 . Press and hold the Input button until the button lights
green to indicate preset mode (approximately 2 seconds) .
• The I/O button becomes unlit.
• The LCD display shows Preset Mode and the name
of the last selected preset (if any).
If no preset has been named in the MKP or if no preset
has been selected, the LCD window shows [Not Set].
2 . Use the Select knob to scroll through the available presets
until the LCD display shows the desired preset name. The
Take button starts to blink.
3 . Press the Take button to recall the preset.
4 . To exit preset mode, press and hold the Input button, until
it lights amber to indicate I/O selection mode
(approximately 2 seconds).
Adjusting the audio output
SELECT
TAKE OUTPUT
SELECT
HOLD
VOLUME
INPUT
Figure 3-6 — Suggested button labels for audio
volume mode