Extron Electronics MPX Plus 866 A Rev. B - Manual (Page 211)

C-3 MPX Plus 866 A Media Presentation Matrix Switcher • Reference Information
PRELIMINAR
Y
Video output
Number/signal type
RGB/VGA .......................... 6 VGA-QXGA RGBHV, RGBS, RGsB, RsGsBs, (follows input type)
S-video/composite video . 2 S-video, 2 S-video or composite video, and 2 composite video
Connectors
RGB/VGA .......................... 6 female 15-pin HD
S-video/composite video . 2 x 2 female BNC for S-video only (outputs 9 and 10)
2 x 2 female BNC for S-video or composite video pass-through (outputs 11
and 12)
2 x 1 female BNC for composite video only (outputs 7 and 8)
Nominal level ................................ 1 Vp-p for Y of component video or S-video and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video
Minimum/maximum levels
RGB/VGA .......................... Analog: 0.3 V to 1.5 Vp-p with no offset (follows input)
S-video/composite video . Analog: 0.0 V to 2.0 Vp-p with no offset
Impedance ...................................... 75 ohms
Return loss
RGB/VGA .......................... -40 dB @ 5 MHz
S-video/composite video . -30 dB @ 5 MHz
DC offset
S-video/composite video . ±5 mV with input at 0 offset
VGA ..................................... ±10 mV with input at 0 offset
Switching type
RGB/VGA .......................... Triple-Action
S-video/composite video . Vertical interval
Sync
Input type (VGA group) ............... RGBHV, RGBS, RGsB, RsGsBs
Output type (VGA group) ........... RGBHV, RGBS, RGsB, RsGsBs (follows input)
Horizontal frequency (RGB) ........ 15 kHz to 145 kHz
Vertical frequency (RGB) .............. 30 Hz to 170 Hz
Genlock connector......................... 1 BNC female (video input 9)
Standards (S-video and composite video groups)
NTSC 3.58, NTSC 4.43, PAL, SECAM
Input level ...................................... 1.9 V to 5.0 Vp-p
Output level ................................... TTL: 5.0 Vp-p, unterminated for RGBHV, RGBS
Input impedance ........................... 510 ohms
Output impedance ........................ 75 ohms
Max. input voltage ........................ 5.0 Vp-p
Max. propagation delay ............... <65 ns
Polarity............................................ Positive or negative (follows input)