Extron Electronics MPX Plus 866 A Rev. B - Manual (Page 161)

5-55 MPX Plus 866 A Media Presentation Matrix Switcher • Switcher Software
PRELIMINAR
Y
Hardware Status — Provides an overall view of the status of the matrix switcher,
including the primary and secondary power supply status and the
individual voltages, the fan and temperature status, the Remote RS-232 port
configuration, and the installed and updated firmware status (figure 5-33).
Figure 5-33 — Status window
Name Presets — Allows you to assign a name to each of the 32 memory presets.
N Preset names are limited to 12 upper- and lower-case alphanumeric characters,
space, and the _ : = and / characters.
N The following characters are invalid in preset names:
+ ~ , @ = ‘ [ ] { } < > ’ “ ; : | \ and ?.
Show RS-232 Strings — Displays the ASCII commands that are used by the
current configuration. You can refer to these for RS-232 programming.
Initialize — Initializes and clears any or all of the following: ties, presets, audio
configuration, preset names, icon names, and icons.
WCP Audio-input Configuration menu bar selection
Displays the audio gain level setting for a single input or for all inputs
and allows you to change it. The level is expressed as the magnitude (number
of decibels) and polarity (positive, gain or negative, attenuation) of the audio
adjustment.
WCP Preferences menu
Immediate Changes — Causes configuration changes to take
effect immediately.
Hold/Verify Changes — Delays implementation of
configuration changes until the Changes – Take button
is pressed.
Ties as Lines — Displays ties as lines (figure 5-34).
Figure 5-34 — Ties shown as lines