GE Industrial Solutions Entellisys 5.0 User Manual - Manual (Page 274)

Alarms and events 262
A
Attention: Flash File Error in
[CPU A/B/Messngr]. Unable to
disable Flash Pgm
Mode.Replace CPU Contact GE Service for CPU replacement Contact GE Post Sales Service (see How to
contact us on page 2 ).
Caution: Firmware Dwnld
Failed. Err Reading Messnger
Status for [Breaker(s)] An error was detected in confirming the status of a
Messenger prior to upgrading its firmware. Contact GE Post Sales Service (see How to
contact us on page 2 ).
Caution: Firmware Dwnld
Failed. Err Reading Messnger
Status during Switch for
[Breaker(s)] An error was detected in confirming the status of a
Messenger after its firmware has been updated. Contact GE Post Sales Service (see How to
contact us on page 2 ).
Caution: Settings Update
Failed.Retry will Occur in 30
minutes An attempt to update the local settings file was
unsuccessful and a retry will be attempted in the
specified time period. If this error is repeated, Contact GE Post Sales
Service (see
How to contact us on page 2 ).
Caution: IP Error X For IP
Address [n.n.n.n] The HMI encountered an error in establishing a
TFTP session with a CPU.
Note: FTP Error X An error has occurred during FTP protocol transfer
with a CPU. Contact GE Service. Contact GE Post Sales Service (see How to
contact us on page 2 ).
Note: TFTP Error X An error has occurred during TFTP protocol transfer
with a CPU. Contact GE Service. Contact GE Post Sales Service (see How to
contact us on page 2 ).
HMI File [Name] Published OK The HMI successfully updated the specified file in
the CPU
HMI File [Name] Retrieved OK The HMI successfully retrieved the specified file
from the CPU
Caution: Error Publishing File
[Name]. Retry An error has occurred attempting to update the
specified file and a retry will be attempted
Caution: Error Retrieving File
[Name]. Retry An error has occurred attempting to retrieve the
specified file and a retry will be attempted
Upgrades Downloaded to CPU
OK The HMI successfully updated the available option
programming for the CPU.
Caution: Upgrades Download
Failed.Unable to Download to
CPU The HMI was unable to update the available option
programming for the CPU. Contact GE Post Sales Service if repeated
attempts fail (see
How to contact us
on page 2 ).
Setting File Updated for
CPU[A/B] The settings file has been successfully updated for
the specified CPU.
Can't Update Setting File for
CPU[A/B] The settings file for the specified CPU could not be
updated.
IP Address in CPUA Written As
[n.n.n.n] From [n.n.n.n] The IP address in CPU A has been changed as
specified.
Table A-4 HMI/CPU Communications Related Events
Event Description Notes and Troubleshooting tips