Ocean Optics OOIBase32 - Manual (Page 88)

9: Time Acquisition Menu Functions
Time Channels A Through F
These tabs allow you to configure a time acquisition process for a single wavelength.
Select one of the Channel tabs to modify information for that channel.
The following options are available from the Channel tabs on the Time Acquisition Channel
Configuration dialog box.
Option Description
Enabled
Enables the time acquisition calculation for the channel. Time acquisition
will not acquire data for this channel if you uncheck this box.
Plotted
Instructs the system to plot the time acquisition data in a spectral
window.
Each channel or combination of channels for a time acquisition means
that you have one less overlay available in the same spectral window as
the time acquisition process. If you specify Channel A for the time
acquisition, Overlay 1 will not be available in the spectral window. If you
specify Channel B for the time acquisition, Overlay 2 will not be visible,
etc.
Spectrometer Channel Determines the spectrometer channel to use for the time acquisition.
Wavelength (nm) Determines the wavelength (in nm) to use for the time acquisition
Bandwidth (pixels)
Determines the bandwidth (in pixels) that the system will average around
the analysis wavelength in a time acquisition.
Factor (multiply)
Contains a multiplicative factor that OOIBase32 will apply to time
acquisition data before it plots or stores the data.
Offset (add)
Contains an additive constant that OOIBase32 will apply to the time
acquisition data after it applies the factor and before it plots or stores the
data.
78 000-20000-020-02-0505