beautypg.com

Time acquisition parameters files, Repeats for all channels – Ocean Optics OOIBase32 User Manual

Page 131

background image

C: File Formats

NLCoef7=0.000000e+000

ChannelEnabled=1

DisplayStart=500.000000

DisplayEnd=777.945801

DisplayStartPixel=429

DisplayEndPixel=1205

ReferenceChannel=0

ReferenceType=0

ReferenceWavelength=800.000000

ReferenceWavelengthPixel=1351

ReferenceBandwidthStart=500.000000

ReferenceBandwidthStartPixel=426

ReferenceBandwidthEnd=600.000000

ReferenceBandwidthEndPixel=723

<<>>

Time Acquisition Parameters Files

The Time Acquisition Parameters File contains all of the information and parameters specified for a time
acquisition process. The file includes the preference for streaming all data to disk (1 if stream data to disk,
0 if not), the filename specified if data streams to disk, and the preference for saving every acquisition or
using a delay between acquisitions (1 if save every acquisition, 0 if use delay).

The file specifies the initial delay after the start of the time acquisition and the unit of time for the delay.
It specifies how frequently the data is collected and the unit of time for the frequency. It also specifies the
duration of the time acquisition process and the unit of time for the duration.

Also included is the preference for acquiring data until manually stopped), the preference for showing
values in the status bar (1 if values shown, 0 if not), and the log frequency or number of acquisitions
before data is streamed to disk.

For each time channel (Channels A through F) used, the file lists the channel state (1 if enabled, 0 if not
enabled). Then the file lists the Wavelength selected, the Pixel for the selected wavelength, the bandwidth
for the current analysis wavelength, the multiplicative factor specified, the additive offset specified, and if
the data is plotted (1 if displayed, 0 if not displayed). Finally, the file contains the name of the chosen
spectrometer channel (Ocean Optics has not enabled the Rate Only and Rate Bandwidth functions in this
release of OOIBase32).

For each time channel combination (Combinations 1 and 2) used, the file lists the channel state (1 if
enabled, 0 if not enabled), the multiplicative factor specified, and the additive offset specified. Then the
file lists the first and second time channels for the combination calculation (A through F and Combo 1).
Finally, the mathematical operation is specified -- add, subtract, multiply or divide the results of the two
time channels. (Ocean Optics has not enabled the Rate Only and Rate Bandwidth functions in this release
of OOIBase32.)

The following is an example of a Time Acquisition Parameters File:

[Acquisition Parameters]

StreamDataToDisk=0

Filename=TestTime

SaveEveryAcquisition=0

InitialDelay=10

LogFrequency=100

SaveFullSpectrum=0

InitialDelayUnit=Seconds

000-20000-020-02-0505

121