Rainbow Electronics 900 - Manual (Page 53)

FLYFOT-M260-MODULE
Page: 53 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
Personal Unblocking Key needed to change the PIN.
See above conditions of use.
7.2 PIN remaining attempt number +CPINC
7.2.1 Description :
This specific command is used to get the number of valid attempts for PIN1 (CHV1), PIN2 (CHV2),
PUK1 (UNBLOCK CHV1) and PUK2 (UNBLOCK CHV2) identifiers.
7.2.2 Syntax :
Command syntax : AT+CPINC
Response syntax : +CPINC : ,,,
Command
Possible responses
AT+CPINC
Note : Get the number of attempts left
+CPINC : 2,3,10,10
OK
Note : First CHV1 attempt was a failure
AT+CPINC?
Note : Get current values
+CPINC : 2,3,10,10
OK
Note : First attempt was a failure
AT+CPINC=?
Note : Get possible values OK
7.2.3 Defined values
, are the attempts left for PIN1, PIN2 (0 = blocked, 3 max)
, are the attempts left for PUK1, PUK2 (0 = blocked, 10 max)
For this to work, the card should be present at the time of initialization, otherwise an error will be sent
(+CME ERROR : 10).
Note: if PIN2 not aviable , the n2 and k2 maybe 255
7.3 Facility lock +CLCK
7.3.1 Description:
This command is used by the application to lock, unlock or interrogate an ME or network facility .
Note: Test SIM cards (with MCC=001 & MNC=01) doesn’t check “PS”, “PN”, “PU”, “PP” and “PC”
locks.
7.3.2 Syntax :
Command syntax: AT+CLCK= ,[,[,] ]
Response syntax: +CLCK: [ , ]+CLCK: , [ … ] ]
Command
Possible responses